The work we do
24 years on Viking alone means most diagnoses take minutes, not visits. Here is the work we do every week, and the signs it’s time to call.
When is it time for a repair?
Five signs worth a call.
Temperature fluctuations
Food spoiling early or a freezer that won’t hold cold, often a failing thermostat or compressor.
Unusual noise
Grinding, buzzing, or clicking from a fridge built to run quietly points to a fan motor or compressor.
Water leaking
Puddles inside or beneath the unit usually mean a clogged defrost drain or a compromised water line.
Frost buildup
Excess ice in the freezer traces back to a defrost system fault or a tired door gasket.
Lights or display out
A dark interior or a blank panel can signal an electrical fault well beyond a burned out bulb.
Viking · Refrigeration
Refrigeration repairs
Refrigerator not cooling
Temperature drift, warm zones, or food spoiling early. Usually a failing thermostat, sealed system, or compressor.
Freezer not freezing
Soft ice cream and frost on the walls point to a defrost system or evaporator fan that has failed.
Heavy frost buildup
Excess ice in the compartment traces back to a defrost heater, a terminator, or a tired door gasket.
Door not sealing
A broken vacuum seal lets cold escape and runs the compressor hard. We restore airtight gasket integrity.
Ice maker not making ice
No ice, low production, or leaks at the water inlet valve, diagnosed and repaired in one visit.
Water leaking from the bottom
A clogged defrost drain or a split water line, traced to the source and sealed properly.
Buzzing and loud operation
Viking refrigerators run nearly silent. Grinding or buzzing is a fan motor or compressor calling for attention.
Condenser and error codes
"Vacuum Condenser" and "Service" codes, control board errors, and light faults, cleared and corrected.
Wine storage temperature
Dual zone drift and humidity faults that threaten a cellar, recalibrated to spec.
Viking · Cooking
Cooking repairs
Oven won’t heat or hold temp
Failed igniters and bake elements restored for consistent, calibrated baking heat.
Uneven baking
Convection fan motor failures and airflow faults that cook one side faster than the other.
Burner won’t light or clicks
Continuous clicking and spark module faults on dual stacked sealed burners, corrected.
Range flame control
Gas regulator pressure and manifold flow issues that make a low simmer impossible.
Touch panel and display errors
Unresponsive touchscreens and digital error codes diagnosed at the board level.
Door and gasket heat loss
Hinge tension and gasket seals restored so the oven holds its heat where it belongs.
We fix it all